9 November, 2001 RSS SET UP
APPENDIX-1
APPENDIX 1 (FOR MODEL R-C2)
1. RSS (REMOTE SERVICE SYSTEM)
1.1 RSS SET UP
!
CAUTION
Unplug the machine power cord before starting the following procedure.
1. Remove the connector cover [A] (1 clip) and disconnect the cable.
2. Remove the rear cover [B] (4 screws).
3. Remove the duplex connector cover [C] (1 screw) and the lower rear cover [D]
(2 screws).
4. Install the RSS board [E] (2 screws).
5. Install the harness [F] between the RSS board and the SBCU board (CN512).
When connecting only one machine to the line adapter, skip step 6.
6. Set the jumper switch [G] on the RSS board as shown (default setting: 1-2).
7. Remove the cover [H] from the lower rear cover.
B027R515.WMF
B027R705.WMF
B027I900.WMF
B027I305.WMF
[A]
[B]
[E]
[F]
[H]
[C]
[D]
[G]
To Next Page
Loading...
