Getting Started
18
1
10.
Operation switch
Press to turn the power on (the On indi-
cator goes off). To turn the power off,
press it again (the On indicator goes off).
11. {
{{
{Scanner Stop}
}}
} key
Press if originals are feeding in slanted,
or to cancel scanning while an original is
feeding in.
12.
{
{{
{Sample Copy/Partial Copy}
}}
} key
(copier mode)
• Sample Copy
To check the settings, copy the first
part of an original up to a length of 280
mm. See “Sample Copy”, Copy Refer-
ence.
• Partial Copy
You can choose to copy a specified
part of the original. See “Partial
Copy”, Copy Reference.
13.
{
{{
{Start}
}}
} key
Press to start copying, scanning, or print-
ing.
14.
{
{{
{Clear/Stop}
}}
} key
• Clear
Press to clear a number entered.
• Stop
Press to stop printing.
15.
{
{{
{#}
}}
} key
Press to confirm values entered or items
specified.
16.
Number keys
Press to enter the number of copies and
other data for a selected function.
17.
{
{{
{Original Type}
}}
} key
Press to select the original type. See “Se-
lecting Original Type Setting”, Copy Ref-
erence.
18.
Image density keys
Press to adjust the image density for the
copier or scanner function. See “Adjust-
ing Copy Image Density”, Copy Reference.
19.
Selection keys
Correspond to display items. Press to se-
lect the corresponding item.
20.
Copier function keys (copier
mode)
Press to use the various copier functions,
set the paper cut length, density level,
zoom, and so on.
21.
Data In indicator (printer mode)
Lights when data is sent from the compu-
ter.
NeptuneC1_GBzen_F_FM_pre.book Page 18 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
