User Tools (System Settings)
42
3
Timer Settings
❖
❖❖
❖ Auto Off Timer
After a specified period, following job completion, the machine automatically
turns off, in order to conserve energy. This function is called "Auto Off".
The machine status after Auto Off is referred to as "Off mode". You can spec-
ify the time to elapse before Auto Off is activated.
Note
❒ Default: 14 min.
❒ Enter a time interval between 1 and 240 minutes.
❒ From “Off mode”, the machine is ready to use in 10 seconds.
❒ Auto Off may not work when error messages appear.
❖
❖❖
❖ Energy Saver
When no other key operations are performed, the machine switches to Low
power mode after a specified period.
Note
❒ Default: 7 min.
❒ The time can be set from 1 to 240 minutes.
❖
❖❖
❖ Panel Off Timer
When no other key operations are performed, the machine switches to Energy
Saver mode after a specified period.
• On 60 sec.
• Off
Note
❒ Default: On 60 sec.
❒ Select [On], the time can be set from 10 to 999 seconds.
❖
❖❖
❖ System Auto Reset
The System Reset setting automatically switches the display to its initial con-
dition when no operations are in progress, or when an interrupted job is
cleared. This setting determines the system reset interval.
• On 60 sec.
• Off
Note
❒ Default: On 60 sec.
❒ Select [On], the time can be set from 10 to 999 seconds.
NeptuneC1_GBzen_F_FM_pre.book Page 42 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
