Specifications
72
6
Notes on using translucent paper
Smooth out any curls in the paper before loading it.
Load translucent paper lengthways when possible.
Hemmed paper
When using hemmed paper, wrinkles and other problems may occur on copies.
Use the following procedure when copying onto hemmed paper:
• Copy from the bypass tray.
• Make sure the paper is straight, and align the paper guides of the bypass tray
to the paper size.
• Load only one sheet at a time.
• Remove each copy from the output tray and place it on a flat surface.
Note
❒ Due to the thickness of hemmed paper, copies may be faint, blurred, or wrin-
kled, and paper jams may occur. You may be able to prevent this by copying
on the rear surface of the paper or feeding the bottom of the paper in first.
Unusable Paper
CAUTION:
Important
❒ To prevent faults, do not use any of the following kinds of paper:
• Thermal fax paper
• Art paper
• Aluminum foil
• Carbon paper
• Conductive paper
• OHP transparencies for colour copying
• Paper with perforated lines
❒ Do not use copy paper that has been already copied onto, or a failure could
occur.
• Do not reuse stapled paper. Do not use aluminum foil, carbon-containing
paper or other conductive paper. If you do, there is a danger of fire.
NeptuneC1_GBzen_F_FM_pre.book Page 72 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
