Control Panel
17
1
Control Panel
This illustration shows the control panel of a machine that has all options fully
installed.
1.
{
{{
{User Tools}
}}
}
Press to change default settings and oper-
ating conditions to your requirements.
See p.29 “User Tools (System Settings)”.
It also displays the total number of copies
made. See p.9 “Counter” .
2.
{
{{
{New Job}
}}
} key (copier mode)
Press to make settings for next copy job
and scan the originals during copying.
See “Job Preset”, Copy Reference.
3.
Indicators
Display errors and machine status.
• L: Service Call indicator
• x: Misfeed indicator. See p.52
“xClearing Misfeeds”.
• M: Open Cover indicator
• E: Used Toner Full indicator
• D: Add Toner indicator. See p.50
“DAdding Toner”.
• C: Load Paper indicator
• Set Original: Indicates the machine is
ready to scan.
4.
Display
Displays the keys to operate each func-
tion, operation status, and error messag-
es.
5.
{
{{
{Program}
}}
} key (copier mode)
Press to store or recall frequently used
settings. See “Programs”, Copy Reference.
6.
{
{{
{Clear Modes}
}}
} key
Press to clear the current settings.
7.
{
{{
{Energy Saver}
}}
}key
Press to enter Energy Saver mode. When
you press this key again, the machine re-
turns to the ready condition. See p.23
“Energy Saver mode”.
8.
{
{{
{Interrupt}
}}
} key
Press to make interrupt copies during
copying or printing. See “Interrupt
Copy”, Copy Reference.
9.
Main power indicator and On in-
dicator
The main power indicator lights when
the main power switch is turned on. The
On indicator lights when the operation
switch is on.
Important
❒ Do not turn off the main power
switch while On indicator is lit.
Doing so may damage the hard
disk.
ABB003S
1 2 5 6 7 8 10 11
21 19 1820 17 16 1415 13 12
493
NeptuneC1_GBzen_F_FM_pre.book Page 17 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
