Troubleshooting
56
4
Changing the Paper Roll Size
Preparation
Be sure to select the paper size with User Tools and the paper size selector. If
you do not, misfeeds might occur. See p.35 “Tray Paper Size”.
Change the left and right of the roll holder when you load different size paper
rolls.
Important
❒ Always follow the instructions below when adjusting the roll holder. Do not
force the roll holder by pulling or sliding it strongly. This could damage it.
Removing the Roll Holder
Setting the Roll Holder
1. Push the roll holder inwards, and then pull
it upwards.
Note
❒
The roll holder is attached with magnets
and a hook.
1. Insert the hook on the roll holder into the
hole (
A
).
2. Hook on the outside and insert the hook into
the hole (
B
).
Note
❒
Make sure the hooks are firmly in the
holes.
NeptuneC1_GBzen_F_FM_pre.book Page 56 Tuesday, December 16, 2003 5:03 PM