Settings You Can Change with User Tools
41
3
❖
❖❖
❖ Paper Volume (printer mode)
When the printer unit is installed, you can specify how the paper volume
should be displayed when a paper roll is loaded in the paper roll tray. You
can specify this setting for each paper roll tray.
• 100%
• 75%
• 50%
• 25%
Note
❒ Default: 100% (paper roll tray 1 or 2)
❒ When a new 175 m roll is loaded, select [100%].
❖
❖❖
❖ Adj.Print Positn.
You can specify the horizontal print position. You can specify this for the pa-
per type (paper roll 1 or 2, cut paper)
Note
❒ Default:
• Metric version: 0.0 mm (paper roll 1 or 2, cut paper)
From –10.0 mm to + 10.0 mm (in 0.1 mm increments)
• Inch version: 0.00 inch (paper roll 1 or 2, cut paper)
From –0.40 inch to +0.40 inch (in 0.01 inch increments)
❖
❖❖
❖ Adj.Scan Position
You can adjust the position of the scan area.
Note
❒ Default: 0
❒ From –10 to +10 (in 1 increments)
❖
❖❖
❖ Print Image Prior (printer mode)
When the printer unit is installed, you can specify the print mode priority.
• Thin Lines
• Gradation
Note
❒ Default: Thin Lines
NeptuneC1_GBzen_F_FM_pre.book Page 41 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
