Ricoh Aficio BP20 - Reinstalling Status Monitor; Removing Status Monitor

P RINTING T ASKS
4.30
6 If the test page prints out correctly, click Yes .
If not, click No to reprint it.
7 When the installation is completed, click Finish .
Reinstalling Status Monitor
1 From the Start menu, select Programs .
2 Select Aficio BP20 Series , and then Maintenance .
3 Click Repair .
4 Click Status Monitor and then click Next .
5 When reinstallation is completed, click Finish .
Removing Status Monitor
1 From the Start menu, select Programs .
2 Select Aficio BP20 Series , and then Maintenance .
3 Check Remove .
4 Click Status Monitor and then click Next .
5 Then your computer asks you to confirm your selection,
click
Yes .
The selected driver and all of its components are removed
from your computer.
6 After the software is removed, click Finish .