Administratior Guide Page 1-3
Basic Network Installation
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses need to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
¾ TCP/IP Address
¾ Gateway Address
¾ Subnet Mask Address
Set IP utility is able to configure these information. If using Set IP utility, you can discover
BP20N and change basic TCP/IP settings. For more information, you can see User’s Guide
on page 2.32~2.34.
To Next Page
Loading...
