Ricoh Aficio BP20 - Ipp

Page 3-10 Administratior Guide
Network Installation Using Internet Services
IPP
Use these instructions to setup IPP using Aficio BP20N.
NOTE: The HTTP settings for the device will have been set up when completing the
Enabling Web Aficio BP20N section.
To complete the installation of the device, perform these steps:
¾ Enable Web Aficio BP20N (see “Enabling Internet Services” on page 3-5).
¾ At the Web Aficio BP20N Home Page for the Aficio BP20N, select the [Network
Administrator] tab.
¾ Click IPP menu in the left frame.
¾ Check if the IPP General Configuration details are correct. If any of the details
of IPP General are incorrect then enter the correct information.
¾ Click the [Apply] button to implement any changes.
¾ Click IPP Security link under the top menu.
¾ Check if the IPP Security details are correct. If any of the details of IPP Security are
incorrect then enter the correct information.
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Reset] button to cancel any changes made and return to the
previous values.
1
2
3
4
5
6
7
8