Network Settings
21
1
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both Ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When POP before SMTP is set to [On], also make setting for Reception Proto-
col and POP3/IMAP4 Settings.
❒ When setting POP before SMTP to [On], check POP3 port number in E-mail
Communication Port.
Reference
p.45 “Interface Settings”
p.51 “File Transfer”
IEEE 802.11b (wireless LAN)
This section lists the settings required for sending e-mail with IEEE 802.11b
(wireless LAN).
For details about how to specify the settings, see "Interface Setting" and "File
Transfer".
File Transfer SMTP Server Necessary
File Transfer SMTP Authentication As required
File Transfer POP before SMTP As required
File Transfer Reception Protocol As required
File Transfer POP3/IMAP4 Settings As required
File Transfer Admin. E-mail Address As required
File Transfer E-mail Communication Port As required
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Necessary
Interface Settings/Network IPv4 Gateway Address Necessary
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Necessary
Interface Settings/Network LAN Type Necessary
Interface Settings/Network Permit SNMPv3 Communictn. As required
Interface Settings/Network Permit SSL/TLS Comm. As required
Menu User Tool Setting Requirements
To Next Page
Loading...
Need help?
General
