Administrator Tools
63
2
Entering the search base
A Select [Search Base] using {U} or {T}, and then press the {OK} key.
Select a route folder to start the search. E-mail addresses registered in the se-
lected folder are search targets.
B Enter the Search Base, and then press the {OK} key.
For example, if the search target is the sales department of ABC company, en-
ter "dc=sales department, o=ABC". (In this example, the description is for an
active directory. "dc" is for the organization unit, and "o" is for the company.)
Search base registration may be required depending on your server environ-
ment. When registration is required, unspecified searches will result in error.
Check your server environment and enter any required specifications.
Entering a port number
A Select [Port No.] using {U} or {T}, and then press the {OK} key.
Specify the port number for communicating with the LDAP server. Specify a
port that matches your environment.
B Enter Port No. using the number keys and then press the {OK} key.
When SSL is set to [On], the port number automatically changes to "636".
To Next Page
Loading...
Need help?
General
