SP4xxx: Scanner
D017/D018/D019/D020 5-42 SM
3 Book: Left [0 to 3.0 / 1.0 / 0.1 mm / step]
4 Book: Right
5 ADF: Leading Edge
7 ADF: Right
8 ADF: Left
[0 to 3.0 / 0.0 / 0.1 mm / step]
Scanner Free Run
4013
Performs a scanner free run with the exposure lamp on or off.
001 Lamp: ON
002 Lamp: OFF
[0 to 1 / 0 / 1]
0=Off, 1=On
Scanner Free Run
4014
Performs a scanner free run with the exposure lamp on.
Note: The free run is done for full size (A3/DLT).
1 HP Detection Enable
2 HP Detection Disable
 Touch [Execute] to start this feature.
 Press the D (Clear/Stop) key to stop.
ADF Scan Glass Dust Check
4020
This function checks the narrow scanning glass of the ADF for dust that can
cause black lines in copies. If dust is detected a system banner message is
displayed, but processing does not stop.
Check On/Off Change
1
Issues a warning if there is dust on the narrow scanning glass of the ADF
when the original size is detected before a job starts. This function can
detect dust on the white plate above the scanning glass, as well as dust on
the glass. Sensitivity of the level of detection is adjusted with SP4020 2.
[0 to 1 / 0 / 1]
To Next Page
Loading...
Need help?
General