Registering Folders
239
7
Changing the registered NCP folder
This section describes how to change the register NCP folder.
A Press [Change] under "Path".
B Enter the path where the folder is located, and then press [OK].
You can also use Browse Network to specify a new folder. For details, see "Lo-
cating the NCP folder manually".
Reference
p.237 “Locate the NCP folder manually”
p.237 “Locating the NCP folder using Browse Network”
p.239 “Changing the protocol”
Changing the protocol
This section describes how to change the protocol.
A Press [SMB], or [FTP].
B A confirmation message appears. Press [Yes].
Changing the protocol will clear all settings made under the previous proto-
col.
C Enter each item again.
Reference
p.223 “Registering a SMB Folder”
p.230 “Registering a FTP Folder”
To Next Page
Loading...
