No paper in tray.
The indicated tray is out of paper. Add more paper.
Paper in Finisher
There is paper left in the finisher. Open the finisher cover and remove the paper.
Paper in Finisher. Open cover and remove the paper.
There is paper left in the finisher. Open the finisher cover and remove the paper.
Paper size/type mismatch. Change settings to: A4 (Recycled)
The paper type and size in all trays are not the same as the paper tray type and size setting, when Auto
Paper Select mode is selected. Press [Change] to change the settings, press [Job Reset] to reset the job, or
press [FormFeed] to force printing.
Malfunction: (tray name)
There is a problem with the paper tray motor. Select a different tray and force printing, or press [Reset Job]
to reset the job.
Parallel I/F Error
The printer's self diagnostic test failed due to a loopback error. Replace the IEEE 1284 board that caused
the error.
For details, see p.54 "Installing the Interface Units".
Printer Font Error.
There are problems with the printer's font file.
Contact your sales or service representative.
[Print] without below mode? [Staple] [Punch] [Staple/Punch]
Continue printing without using the function listed on the third line of the display. Press [OK] to cancel the
displayed modes and resume printing.
Printing suspended. Resume printing from PC side.
Printing has been suspended. Resume the print job from your computer.
Problem with Hard Disk Please call service.
The printer cannot detect a hard disk. It may be incorrectly installed.
Check if it is installed properly or contact your sales or service representative.
For details about installing the unit, see p.54 "Installing the Interface Units".
Problem:Wireless card Please call service.
The printer has detected a wireless LAN board or Bluetooth failure, or it could not detect a wireless card.
It may be incorrectly installed.
9. Troubleshooting
202
To Next Page
Loading...
Need help?
General