SERVICE PROGRAM MODE TABLES
SM 5-69 B064 Series/B140 Series/G126
Service
Tables
5141* Tray for Tab Sheets (B064 only)
Sets the height of the tabs for each paper source for tab sheets. The height of a tab is
measured from the edge of the paper to the edge of the tab.
011 Tab Height: By-pass
012 Tab Height: Tray 1
013 Tab Height: Tray 2
014 Tab Height: Tray 3
015 Tab Height: Tray 4
016 Tab Height: Tray 5
[0~152/0.1 mm]
The height of the tab is the value set for this SP
multiplied by 0.1. The default tab height then is:
130 x 0.1 = 13 mm
To change this setting, measure the height of the tab
in millimeters, multiply by 10, then input the result.
For example, if the measured height of the tab is 10
millimeters, enter “100”.
5150 Bypass Length Setting
Sets up the by-pass tray for long paper.
[0~1/1]
0: Off
1: On. Sets the tray for feeding paper up to 600 mm long.
With this SP selected on, paper jams are not detected in the paper path.
5154 Exit Tray Set
001 Limitless
Allows ‘limitless’ paper output.
[0~1/1]
0: Off
1: On. Once the initial paper exit is full, another will be selected automatically.
Switch this SP on only in the job queuing mode, i.e. when printing jobs in the
order of selection with the print priority function. Print priority is set in the User
Tools mode (System Settings> General Features> Print Priority> Job Order.)
002 Override
Allows overriding of the setting for SP5154-001.
[0~1/1]
0: Off
1: On
This SP can be set only when on is selected for SP5154-001. Changing this
setting has no effect on the machine when SP5154-001 is off.
To Next Page
Loading...
