Ricoh B064 - Page 487

SERVICE PROGRAM MODE TABLES
SM 5-85 B064 Series/B140 Series/G126
Service
Tables
5844* USB
001 Transfer Rate
Sets the speed for USB data transmission.
[Full Speed]
[Auto Change]
002 Vendor ID
Sets the vendor ID:
Initial Setting: 0x05A Ricoh Company
[0x0000~0xFFFF/1] DFU
003 Product ID
Sets the product ID.
[0x0000~0xFFFF/1] DFU
004 Device Release No.
Sets the device release number of the BCD (binary coded decimal) display.
[0000~9999/1] DFU
Enter as a decimal number. NCS converts the number to hexadecimal number
recognized as the BCD.
5845* Delivery Server
These are delivery server settings.
001 FTP Port No.
[0~65535/1]
002 IP Address
Use this SP to set the Scan Router Server address. The IP address under the
transfer tab can be used with the initial system setting.
[0~FFFFFFFF/1]
003 Retry Interval (B064 only)
Sets the time interval before the machine tries again when it goes back to standby
after an error occurs during an image transfer with the delivery scanner or SMTP
server.
[60~900/1]
004 Number of Retries (B064 only)
Sets the number of times the machine tries again before it returns to standby after
an error occurs during an image transfer with the delivery or SMTP server.
[0~99/1]
005 Capture Server IP Address (B064 only)
Sets the capture server IP address for the capture feature.
[0~0xFFFFFFF]
006 Delivery Error Display Time
Use this setting to set the length of time that the message is shown when a test
error occurs during document transfer with the NetFile application and an external
device.
[0~999/1]
007 Delivery Options (B064 only)
Connects to the Scan Router server for delivery of scanned documents.
[0~1/1]
0: No connection to Scan Router delivery server
1: Connected to Scan Router server for delivery of scanned documents.