JOGGER FENCE ADJUSTMENT
B468/B469/B674 18 SM
6. Push the left edge of the adjustment board against the front fence.
7. At the back of the unit, loosen screw [A] to release jogger shaft [B].
8. At the front, check the position of the upper left corner. The leading edge
should be parallel to the stay.
• If the left corner of the board is low [C], lower the jogger shaft [B] until the
leading edge of the board is parallel to the stay then tighten screw [A].
• If the left corner of the board is high [D], raise the jogger shaft [B] until the
edge is parallel then tighten the screw [A].
B468R907.WMF
B468R908.WMF
B468R909.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
