JOGGER FENCE ADJUSTMENT
SM 19 B468/B469/B674
3000-Sheet
Finisher
B468/B469/
B674
9. Push the right edge of the adjustment board against the back fence.
10. At the back of the unit, loosen screw [A] to release jogger shaft [B].
11. At the front, check the position of the upper right corner. The leading edge
should be parallel to the stay.
• If the right corner of the board is high [C], raise the jogger shaft [B] until the
leading edge of the board is parallel to the stay then tighten screw [A].
• If the right corner of the board is low [D], lower the jogger shaft [B] until the
edge is parallel then tighten the screw [A].
12. Reassemble the finisher.
13. Print three booklet sets of 2 or 3 sheets each.
B468R911.WMF
B468R912.WMF
B468R910.WMF
[C]
[D]
[A]
[B]
To Next Page
Loading...
