JOGGER FENCE ADJUSTMENT
B468/B469/B674 22 SM
18. Do the following procedures.
or Over 2 mm
(1) Loosen the rear jogger fence shaft screw, raise the rear jogger fence shaft
then tighten the screw.
(2) Loosen the screw of the front jogger fence shaft, lower the shaft to bring
the front jogger fence flush against the paper, then tighten the screw.
or Over 2 mm
(1) Loosen the rear jogger fence screw, lower the rear jogger fence shaft, then
tighten the screw.
(2) Loosen the screw of the front jogger fence shaft, raise the shaft to bring the
front jogger fence flush against the paper, then tighten the screw.
NOTE: Be sure to raise or lower both shafts by the same number of marked
increments.
19. Repeat Step 18 until the gaps are all less than 2 mm.
rear
B468R915.WMF
B468R916.WMF
To Next Page
Loading...
