Guide to the Printer
14
❒ If printed A3 short-edge feed or 11×17 short-edge feed sheets fall off the standard
tray, raise the fence to secure them.
7. Upper right cover
Open this to replace the toner cartridge.
8. Vent
This helps keep internal components from overheating. Do not block or obstruct the
vent. Malfunctions may occur due to overheating.
9. Controller board
Slide this out to install options such as the memory unit, user account enhance unit, or
printer hard disk.
Plug cables such as the parallel interface cable and Ethernet cable into their connectors.
10. Ethernet port
Use a network interface cable to connect the printer to a network.
11. USB port
Use a USB cable to connect the printer to the host computer.
12. Expansion Card Slots
Install expansion cards in these slots. There are three slots.
When you use the expansion card, use the under slot.
13. Optional interface board slot
Insert an optional gigabit ethernet board, IEEE 1394 interface board, IEEE 802.11b in-
terface unit, wireless interface board, IEEE 1284 interface board, or USB host interface
unit in this slot. Only one board can be inserted at a time.
14. Bypass tray extension
Pull this out to load paper in the bypass tray when its length is longer than A4 L.
15. Bypass tray
Use to print on thick paper, OHP transparencies, custom size paper, and plain paper.
Up to 100 sheets of plain paper can be loaded.
16. Vent
This helps keep internal components from overheating. Do not block or obstruct the
vent. Malfunctions may occur due to overheating.
To Next Page
Loading...
Need help?
General
