Basics
32
2
Basic Procedure
When Auto Cycle mode is on, you
can process masters and make prints
in a single operation.
Note
❒ You can process masters and make
prints in a single operation. See
p.38 “Auto Cycle”.
❒ If the machine has user codes set,
enter your user code using the
number keys, and then press the
{OK} key.
Reference
See p.117 “User Code”.
A Make sure no previous settings
remain.
Note
❒ If previous settings remain, press
the {Clear Modes/Energy Saver} key
before entering your settings.
B Place the originals.
Reference
See p.30 “Placing Originals”.
C Make sure the {Master Making} mode
select key is lit.
Note
❒ If it is not lit, press the {Master
Making} mode select key.
D Make the necessary settings.
E Press the {Start} key.
Master making starts.
Note
❒ Press the {Proof} key to check
the image before making prints.
Reference
To change the image position,
see p.40 “Adjusting the Print
Image Position”.
F Make sure the {Print} mode select
key is lit.
ANT015S
ANT010S
ANT014S
To Next Page
Loading...
