Ricoh DX 3243 - Placing a New Roll of Tape in the Tape Dispenser (Optional)

Placing a New Roll of Tape in the Tape Dispenser (Optional)
83
4
Placing a New Roll of Tape in the Tape
Dispenser (Optional)
Note
❒ Make sure that the main switch is
turned on and the power switch of
the tape dispenser is off.
A Open the cover of the tape dis-
penser.
B As shown, put the roll in the dis-
penser.
Note
❒ Make sure that the tape is in-
stalled in the proper direction. If
it is not in the correct direction,
the tape dispenser will not work
correctly.
C Feed the leading edge of the roll in
the dispensing slot until it stops.
Note
❒ Push the tape as far as possible
through the slot.
D Turn on the power switch of the
tape dispenser.
E Press the manual cut button to trim
off the leading edge of the tape.
TSLP010E
TSLP011E
TSLP012E
TSLP013E
On
Off
TSLP014E