Basics
38
2
Auto Cycle
Using the default settings, you can
process masters and make prints in a
single operation. This is called "Auto
Cycle".
A Make sure the {Auto Cycle} key is
lit.
Note
❒ If it is not lit, press the {Auto Cy-
cle} key.
B Place your originals.
Reference
See p.30 “Placing Originals”.
C Make sure the {Master Making} mode
select key is lit.
Note
❒ If it is not lit, press the {Master
Making} mode select key.
D Make the necessary settings.
E Enter the required number of prints
using the number keys.
F Press the {Start} key.
Note
❒ When the print job finishes, press
the {Clear Modes} key. Previously
entered job settings are cleared.
ANT012S
ANT008S
ANT015S
To Next Page
Loading...
