Loading Paper In The Bypass Feed Table
☛ Regarding the bypass feed table,see page.31
1
Lift the paper hold lever.
❐
Swing out the extender if setting copy
paper larger than A4
:
, 8
1/2
" x 11"
:
.
2
Insert copy paper until it stops.
❐
The image will be copied on the side
of paper that you place face up.
❐
If the guides are not flush with the
copy paper,a skew image or paper
that you place face up.
❐
Fan OHP transparencies or translucent
paper to get air between them to avoid
multi sheet feed(multiple sheets fed to-
gether at the same time).
3
Lower the paper hold lever.
❐
If you have set copy paper larger than
A4
:
, 8
1/2
" x 11"
:
, support the trailing
edge of copy paper with your hand
when lowering the paper holder.
gkf-ueg7
LOADING PAPER
49
To Next Page
Loading...
