Notes For Copy Paper
❐
Load paper with the copy side
down
in the paper tray, and with the copy side
up
in the bypass feed table. If copies are curled, try turning the copy paper over
in the tray or table. If there is no improvement, change to copy paper with less
curl.
❐
Correct curls in copy paper before loading.
❐
Fan copy paper to get air between the sheets before loading.
❐
OHP transparencies, translucent paper, and adhesive labels should be set in
the bypass feed table.
❐
OHP transparencies, translucent paper, and adhesive labels should be fanned
to get air between the sheets before loading.
❐
Do not touch copy paper if your fingers are wet or oily; finger prints may appear
on the copy.
❐
When making two-sided copies,do not load paper in the paper tray for copying
the reverse side. Use the bypass feed table.
Paper Storage
Paper should always be stored properly. Improperly stored paper might
result in poor image reproduction, creased copies, and paper misfeeds.
Generally, avoid curling and absorption of moisture.
❐
Avoid storing paper in humid areas. Under high temperature and high humidity,
or low temperature and low humidity conditions, store paper in a vinyl bag.
❐
Do not store paper where it will be exposed to heat.
❐
Store on a flat surface.
❐
Use older stock first.
❐
Do not lay heavy objects on paper.
❐
Keep open reams of paper in the package, and store as you would unopened
paper.
gkf-ueg4
COPY PAPER
17
To Next Page
Loading...
