Ricoh G-P3 - Page 121

SC
[Level]
Symptom Possible Cause/Required Action
An error is detected in the mail
receiving data area of the
HDD at machine initialization.
• Defective HDD
• Power failure during an access to the HDD
1. Initialize the HDD (SP5-832-001).
2. Replace the HDD.
873
[B]
HDD mail transfer error
An error is detected in the mail
transmitting data area of the
HDD at machine initialization.
• Defective HDD
• Power failure during an access to the HDD
1. Initialize the HDD (SP5-832-001).
2. Replace the HDD.
874
[D]
Delete All error 1: HDD
An error is detected while the
all data of the HDD or NVRAM
are formatted physically by the
Data Overwrite Security Unit
(B735).
• Not installed Data Overwrite Security Unit (SD
card)
• Defective HDD
1. Install the Data Overwrite Security Unit (B735).
2. Replace the HDD.
875
[D]
Delete All error 2: Data area
An error is detected while the
all data of the HDD or NVRAM
are formatted logically by the
Data Overwrite Security Unit
(B735).
• The logical format for HDD fails.
1. Turn the main switch off/on and try the operation
again.
876 Log Data Error
001
[D]
Log Data Error 1
• An error was detected in the handling of the log data at power on or during machine
operation. This can be caused by switching the machine off while it is operating.
1. Initialize the HDD with SP5832-004.
002
[D]
Log Data Error 2
• The DESS module is not installed when the DESS module is set to ON.
1. Replace the DESS module.
4. Troubleshooting
120
4