Ricoh GelSprinter GX e2600 - Page 354

• For details about the Key Repeat, see p.159 "Performing Maintenance using the Control Panel
(Maintenance Menu)".
Adjusting the Angle of the Control Panel
You can adjust the angle of the control panel for easier usage.
Use the following procedure to adjust the angle of the control panel.
Raising the Control Panel
1. Raise the control panel by carefully pulling it upward and forward.
BPR189S
2. Insert the stopper on the back of the control panel into one of the grooves beneath.
Lowering the Control Panel
1. Carefully pull the control panel slightly forward ( ).
BPR190S
2. Lower the control panel ( ).
• You can set the tilt to one of three angles.
1. Read This First
24
1