4. Remove the orange tape from the printer body.
• We recommend you keep the box, so you can use it again when relocating the printer.
•
Remove all the orange tape, except the tape around the power cord.
• USB and LAN cables are not supplied.
Attaching the Options
Attaching the Multi Bypass Tray BY1000
1. Make sure the printer's power cord is unplugged.
2. Take the bypass tray out of its box.
3. Remove the orange tape from the bypass tray.
4. Fully insert the bypass tray.
5. When using the bypass tray, pull out its extension and adjust the side guides according to
the size of the loaded paper.
After attaching the paper feed unit, you must register where to start printing on paper loaded in the paper
feed unit.
Setting Up the Hardware
41
To Next Page
Loading...
Need help?
General