Ricoh GelSprinter GX e2600 - Page 678

Ready
|■| |■| |■| |■|
Update complete
Power Off->On
Updating...
>_________________
Accessing NVRAM
>>>>>>>>>>>>>>____
Verifying
>>>>>>>>>>>>______
Waiting for Data
>>________________
Overwriting
>>>_______________
Extracting data
>>>_______________
Receiving Data
>>>_______________
∗
The progress of the update is
displayed on the LCD of the
printer’s control panel in
the
following order.
9. After the update, check that the new firmware version is
displayed.
Use the following procedure to check the version of your
printer
.
1. Press the [Menu] key on the printer’s control panel.
2. Select [List/Test Print].
3. Execute [Config. Page].
4. The System Summary is printed.
5. Check the version number under “System Version”.
8. Updating star
ts.
Check the update progress displayed on the LCD of the printer’s
contr
ol panel.
The update progress should be as shown in the diagram on the
r
ight.
When the “Ready” message appears, the p
rinter is ready to
print.
Ready
|■| |■| |■| |■|
10. The update is complete.
9