4. While pressing down the release lever of the side fence, slide the side fences outward.
5. While pinching the release lever of the end fence, slide the end fence outward.
6. Square the paper and load it print side down.
Do not stack paper over the limit mark.
7. Align the end and side fences gently against the paper you loaded.
Make sure that there is no space between the paper and the side fences or end fence.
When loading thin paper, keep the gap between the paper and each side fence within 0.5 mm. If
the gap is too wide, creases may occur.
9. Adding Paper and Toner
182
To Next Page
Loading...
