Replenishing the Staples
Contact your consumable supplier and prepare new staples for replenishment when the "Staples are
almost out." message is displayed. Replace the staples after the message prompting replacement is
displayed on the control panel.
• When operating the machine, do not put your hand inside the booklet finisher tray of the
finisher's staple unit. You may trap your fingers in the machine's gap and injury can result.
• Stapling failures or jams may occur if you use a staple cartridge other than that recommended.
Confirming the supplier of consumables
Press [Maintnc./Inquiry/Mach. Info] on the [Check Status] screen to display the telephone number
for ordering consumables.
See "Contact Information", User Guide (Full Version).
Replenishing the staples
Replenish the staples while watching the video displayed on the screen for the procedure.
1. Press [Watch Video].
Press [Check Status] and then press [Check] under the message regarding the staples on the
[Mach./Applic. Stat] tab.
2. Press the play ( ) key.
3. Replenish the staples while watching the video.
• If you cannot raise the upper unit by holding on both ends of the cartridge, there are staples still
remaining inside. Continue using the machine without replenishing the staples.
Replenishing the Staples
241
To Next Page
Loading...
