7. Attach the paper supports by fitting the groove of the paper supports into the supporting
plates of the fences.
8. Check whether the paper supports and side fences are connected by moving the side
fences.
9. Align the end fence and side fences with the paper size to be loaded, and then load the
paper.
10. Carefully slide the paper tray fully in.
11. Specify the paper type and thickness.
page 210 "Specifying Paper Type and Thickness Settings"
When loading paper of a size that is not automatically detected, specify the paper size.
9. Adding Paper and Toner
204
To Next Page
Loading...
