Z-fold support tray 2
• Finisher shift tray
1. If the finisher is installed with the cooling fan unit, press the [Suspend / Resume]
key near the paper outlet port.
page 377 "Removing Prints from Finisher SR4150/Booklet Finisher SR4160 during
Printing"
If the finisher is not installed with the cooling fan unit, proceed to Step 2.
2. Remove the stack of paper from the finisher shift tray.
3. Attach the Z-fold support tray 3.
The back of the Z-fold support tray 3 is embossed with "3".
Z-fold support tray 3
Attach the Z-fold support tray 3 by inserting the two protrusions on its underside into the
holes on the finisher shift tray.
If the finisher is installed with the cooling fan unit, proceed to Step 4.
4. Press the [Suspend / Resume] key.
11. Specifications for The Machine
380
To Next Page
Loading...
