Ricoh M C251FW - Page 240

Item Description Value
Export to NFC Specifies whether or not to
synchronize the data you have
configured using the control panel and
Web Image Monitor with the data
stored in NFC.
You can read and write the data in
NFC by using the application
corresponding to the machine.
• Off
Does not synchronize the data
you have configured using the
control panel and Web Image
Monitor with the data stored in
NFC.
• On
Synchronizes the data you have
configured using the control
panel and Web Image Monitor
with the data stored in NFC.
Default: [On]
Auto Continue
Item Description Value
Auto Continue Sets the machine to ignore an error
with paper size or type and continue
printing. The printing stops temporarily
when an error is detected, and restarts
automatically after about ten seconds
using the settings made on the control
panel.
However, if the size of paper specified
on the control panel and that of the
paper loaded in the paper tray or the
paper size specified for the print job
do not match when printing restarts, it
may cause a paper jam.
• Off
• On
Default: [Off]
Toner Saving
Item Description Value
Toner Saving Sets the machine to print using a
reduced amount of toner (for prints
made by the copier function only).
• Off
• On
Default: [Off]
7. Configuring the Machine Using the Control Panel
238