EasyManua.ls Logo

Ricoh M C251FW - Notes to Users Regarding Facsimile Unit (New Zealand)

Ricoh M C251FW
448 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
This product complies with the essential requirements and provisions of Directive 2014/53/EU.
The CE Declaration of Conformity is available by accessing the URL:
https://www.ricoh.com/products/ce_doc2/
and selecting the product applicable.
Operating frequency band: 2412-2462 MHz, 5150-5350MHz
RF Output Power: 17dBm - 802.11b / 15dBm – 802.11g / 13dBm – 802.11a / 13dBm –
802.11n / 11dBm – 802.11ac
Operating frequency band: 13.56Mhz
Maximum radio-frequency power: less than 42dB A/m (at 10m)
*Maximum radio-frequency power is depended on power value of reader/writer device.
Outdoor use of the 5GHz band is prohibited.
As this equipment with the radiating part is not intended to be used in close proximity to the human
body, it is recommended to use at least 20cm apart from the user.
NOTES TO USERS REGARDING FACSIMILE UNIT (NEW ZEALAND)
NOTICE TO USERS (NEW ZEALAND)
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates
no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.
This equipment is not capable, under all operating conditions, of correct operation at the higher
speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such
circumstances.
Devices connected to the telephone port may lose their memory if this fax machine is on line for
extended periods. To prevent this, such devices should have the facility for battery or similar
backup of memory.
This device may be subject to ringing or bell tinkle when certain other devices are connected to the
same line. If this occurs, the problem should not be referred to the Telecom Faults Service.
This equipment should not be used under any circumstances that may constitute a nuisance to other
Telecom customers.
Telepermitted equipment only may be connected to the auxiliary telephone port. The auxiliary
telephone port is not specifically designed for 3-wire connected equipment that may not respond to
incoming ringing when attached to this port.
12. Appendix
428

Table of Contents

Related product manuals