Message Causes Solutions
RX Communication
Error
A reception error occurred, and
the fax could not be received
correctly.
If possible, contact the sender of the fax
and ask them to resend it.
Scan (NW)
Disconnected
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Reconnect the Ethernet cable properly,
and then try the operation again.
Scan (USB)
Disconnected
The USB cable was
disconnected while scanning
from a computer.
Reconnect the USB cable properly, and
then try the operation again.
Server Connection
Failed
A scanned file could not be sent
because the destination could
not be reached.
Confirm that the destination is registered
correctly, and then try the operation again.
Server Response
Error
An error occurred in
communication with the server
before beginning transmission.
Confirm that the destination is registered
correctly, and then try the operation again.
If the problem could not be solved, contact
the network administrator.
SCXXX A fatal hardware error has
occurred, and the machine
cannot function.
Contact your sales or service
representative.
Set Correct Paper The tray selected in [Select
Paper Tray] under [Fax Settings]
does not contain A4, Letter, or
Legal size paper.
While the message is displayed, press [Set
Size]. A menu for changing the paper size
of the current tray appears.
Load A4/Letter/ Legal size paper in the
tray, and then select the corresponding
paper size.
Note that the paper size setting for the tray
under [Paper Settings] will be changed.
See page 246 "Paper Settings".
10. Troubleshooting
354
To Next Page
Loading...
