4. Press [IPV6 Configuration].
5. Press [IPV6 DHCP].
6. Select [Active] to automatically obtain the IP address or [Inactive] to specify the IP
address manually.
If you have selected [Active], proceed to Step 12.
7. Press [Manually Set Address].
8. Enter the machine's IPv6 address in [Manually Set Address].
9. Enter the prefix length in [Prefix Length:].
10. Enter the gateway address in [Gateway Address:].
11. Press [OK].
12. Turn off the machine, and then turn it back on.
Setup is completed.
11. Configuring Network Settings
400
To Next Page
Loading...
