System SP5-xxx
M052/M053/M054 5-76 SM
124
Reso: Print (Mono)
This is basically adjusted by the remote system.
[0 to 5 / 3 / 1/step]
Selects the resolution for BW print mode. This is basically adjusted by the
remote system.
0: 600dpi/ 1: 400dpi/ 2: 300dpi/ 3: 200dpi/ 4: 150dpi/ 5: 100dpi
126
Reso: Fax (Mono)
This is basically adjusted by the remote system.
[0 to 6 / 3 / 1/step]
Selects the resolution for BW fax mode. This is basically adjusted by the
remote system.
0: 600dpi/ 1: 400dpi/ 2: 300dpi/ 3: 200dpi/ 4: 150dpi/ 5: 100dpi/ 6: 75dpi
127
Reso: Scan (Color)
This is basically adjusted by the remote system.
[0 to 6 / 4 / 1/step]
Selects the resolution for color scanning mode. This is basically adjusted by
the remote system.
0: 600dpi/ 1: 400dpi/ 2: 300dpi/ 3: 200dpi/ 4: 150dpi/ 5: 100dpi/ 6: 75dpi
128
Reso: Scan (Mono)
This is basically adjusted by the remote system.
[0 to 6 / 3 / 1/step]
Selects the resolution for BW scanning mode. This is basically adjusted by
the remote system.
0: 600dpi/ 1: 400dpi/ 2: 300dpi/ 3: 200dpi/ 4: 150dpi/ 5: 100dpi/ 6: 75dpi
141
All Addr Info Switch
[0 to 1 / 1 /1]
Switch this SP off if the system is performing slowly due to a large number of
resources in use. If this SP is switched off, only 2000 documents can be
queued for sending to the Capture Server. (See SP5836-142 below.)
0: Off, 1: On
142
Stand-by Doc Max
Number
[10 to 10000 / 2000 / 1]
This SP sets the maximum number of documents to be held on stand-by
before they are sent to the Capture Server. However, the maximum number
(10,000) cannot be set unless SP5386-141 has been disabled (switched off).
To Next Page
Loading...
