Data Overwrite Security Unit Type I (D362)
M052/M053/M054 2-48 SM
7. Set SP5-836-001 (Capture Function (0:Off 1:On)) to a value of 0 (disable).
8. Execute SP5-878-001 (Option Setup: Data Overwrite Security).
Note: If the installation fails, “Installation failed” is displayed when this SP is executed.
9. Print out the System Settings List and make sure that the option was installed successfully.
10. Turn off the main power switch.
11. Reattach the SD slot cover.
12. Reconnect the network cable.
13. Insert the power cord into the outlet and turn on the main power switch.
14. Execute SP5-990-005 (SP print mode Diagnostic Report).
15. Make sure that ROM number “D3775912B“ and firmware version “1.02m“ appear in both
of the following areas on the report (they must match):
“ROM Number / Firmware Version” – ”HDD Format Option”
”Loading Program”
Configuring “Auto Erase Memory” (Performed by the Customer)
The following procedure is performed by the customer once the above Installation Procedure
has been completed.
1. Press [System Settings].
2. Press [Administrator Tools].
3. Press [Next] three times.
4. Press [Auto Erase Memory Setting].
5. Press [On].
Rev. 11/7/2013
To Next Page
Loading...
