Data Overwrite Security Unit Type I (D362)
SM 2-47 M052/M053/M054
Installation
1. Disconnect the network cable from the machine.
2. Remove the SD slot cover [A] (
×1).
3. Push the SD card for the Data Overwrite Security Unit Type I [B] slowly into Slot 2 (lower
slot), until you hear a click.
IMPORTANT:
If you wish to merge multiple applications onto a single SD card, do the merge now before
moving onto the next step.
4. Insert the power cord into the outlet, and then turn on the main power switch.
5. Access System/Copy SP mode.
6. Do this step only if you are installing the option on a machine that is already in use (not a
new machine):
If the customer wishes to continue using the same hard disk:
Execute all three SP modes below.
SP5-801-014 (Clear DCS Setting)
SP5-832-001 (HDD Formatting (ALL))
SP5-832-002 (HDD Formatting (IMH))
If customer wishes to replace the hard disk with a new one:
Execute SP5-801-014 only.
Note: If the customer continues using the same hard disk, the overwriting of the data
stored on the disk before the option is installed cannot be guaranteed. It is highly
recommended to replace the hard disk with a new one.
Rev. 11/7/2013
To Next Page
Loading...
