3. Press the [ ] or [ ] key to enter characters, and then press [Accept].
You can switch among upper/lower cases, numeric codes, and symbols by pressing [ABC/123].
The characters that can be used are ASCII 0 × 20-0 × 7e (32 bytes).
4. Print a configuration page to confirm the settings.
• The SSID can also be set using a Web browser. For details, see the Web Image Monitor Help, and
"Configuring the Network Interface Board", Software Guide. For details about printing the
configuration page, see "Test Printing", Quick Installation Guide.
Wireless LAN Configuration
67
To Next Page
Loading...
Need help?
General
