• Click [Change] in “Phase 2 User Name”, and then enter the user name set in the RADIUS server.
• Select [CHAP], [MSCHAP], [MSCHAPv2], [PAP], or [MD5] in “Phase 2 Method”.
• Certain methods might not be available, depending on the RADIUS server you want to use.
• Make the following settings according to the operating system you are using:
• Select [On] or [Off] in “Authenticate Server Certificate”.
• Select [On] or [Off] in “Trust Intermediate Certificate Authority”.
• Enter the host name of the RADIUS server in “Server ID”.
• Select [On] or [Off] in “Permit Sub-domain”.
PEAP
• Select [MSCHAPv2] or [TLS] in “Phase 2 Method”.
• When you select [TLS], select the client certificate you want to use in “WPA Client Certificate”.
• When you select [MSCHAPv2],
• click [Change] in “Password”, and then enter the password set in the RADIUS server.
• click [Change] on “Phase 2 User Name”, and then enter the user name set in the RADIUS
server.
• Make the following settings according to the operating system you are using:
• Select [On] or [Off] in “Authenticate Server Certificate”.
• Select [On] or [Off] in “Trust Intermediate Certificate Authority”.
• Enter the host name of the RADIUS server on “Server ID”.
• Select [On] or [Off] in “Permit Sub-domain”.
13. Click [OK].
14. Click [Logout].
15. Quit the Web browser.
• You can select [Certificate 1] or [Certificate 2] in the “Device Certificate” window. Note that if you
select [Certificate 1] in the “Device Certificate” window, you must select [Certificate 1] in the
“IEEE802.11 a” drop down menu in the “Certification” window.
• If there is a problem with settings, you might not be able to communicate with the printer. To identify
the problem, print a network summary.
• If you cannot identify the problem, reset the printer interface to normal, and then repeat the procedure
from the beginning.
4. Configuration
76
To Next Page
Loading...
Need help?
General
