Messages Displayed When Using the Printer
Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
Messages Displayed on the Control Panel When Using the Printer Function
• Before turning off the power, see page 63 "Turning On/Off the Power".
Messages Causes Solutions
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn off the power, and then back on
again. If the message appears again,
contact your service representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk.
Turn off the power, and then back on
again. If the message appears again,
contact your service representative.
"Hardware Problem: USB" An error has occurred in the
USB interface.
Turn off the power, and then back on
again. If the message appears again,
contact your service representative.
"Hardware Problem:
Wireless Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
The wireless LAN board can
be accessed, but an error was
detected.
Turn off the power, and then confirm
the wireless LAN board is inserted
correctly. After confirmation, turn on
the power again. If the message
appears again, contact your service
representative.
"Hardware Problem:
Wireless Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
• The Bluetooth interface
unit was connected while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
Turn off the power, and then confirm
the Bluetooth interface unit is inserted
correctly. After confirmation, turn on
the power again. If the message
appears again, contact your service
representative.
10. Troubleshooting
196
To Next Page
Loading...
Need help?
General
