12. Press [Change].
13. Specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication".
You can specify the IPv4 address range to which this setting is applied, and whether or not to apply
the setting to the parallel and USB interfaces.
14. Press [Exit].
15. Press [On] for "Use Secure Connection (SSL)".
If you are not using secure sockets layer (SSL) for authentication, press [Off].
If you have not registered a global group, proceed to step 22.
If you have registered a global group, proceed to step 16.
If global groups have been registered under Windows server, you can limit the use of functions for
each global group.
You need to create global groups in the Windows server in advance and register in each group the
users to be authenticated. You also need to register in the machine the functions available to the
global group members. Create global groups in the machine by entering the names of the global
groups registered in the Windows Server. (Keep in mind that group names are case sensitive.) Then
specify the machine functions available to each group.
If global groups are not specified, users can use the available functions specified in [*Default
Group]. If global groups are specified, users not registered in global groups can use the available
functions specified in [*Default Group]. By default, all functions are available to *Default Group
members. Specify the limitation on available functions according to user needs.
Windows Authentication
47
To Next Page
Loading...
Need help?
General
