Ricoh PRO C751 - Expansion and Contraction (1)

104
4.8.10 Expansion and Contraction (1)
The leading edge margin is too narrow and the image has shrunk lengthwise.
Paper feed direction
Original
Output
CEZ528
The paper has creased and no print appears where the crease has occurred.
Paper feed direction
Output
Original
CEZ529
Cause:
The paper feed speed of the transfer timing roller is too high.
Solution:
Decrease the feed speed of the transfer timing roller.
1.
In [Advanced Settings] for the custom paper in use, select [20: Transfer
Timing Roller Feed Speed Adj] and reduce the value by 0.1%.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep decreasing the value by 0.1% until the problem is resolved.
If the problem persists even though you have decreased the value by
1.0%, contact your service representative.