107
4.8.13 Decurling Results in Scratches, Streaks, or Creases
Cause:
The paper feed speed of the decurler unit is too high or too low.
Solution:
<If scratches or streaks appear on the side 2 of the paper or continuous
noise results>
You can lessen the problem by decreasing the paper feed speed of the decurler
unit.
1.
In the [Adjustment Settings for Skilled Operators] menu, check the present
degree of decurling (Off, Weak, or Strong) in [0116: Adjust Paper Curl].
2.
In [Advanced Settings] for the custom paper in use, adjust the paper feed
speed of the decurler unit.
• If the degree of decurling is set to "Off", reduce the value in [51: Decurler
Feed Speed Adj: Curl Adj Off] by 0.5%.
• If the degree of decurling is set to "Weak", reduce the value in [52: Decurler
Feed Speed Adj: Curl Adj Weak] by 0.5%.
• If the degree of decurling is set to "Strong", reduce the value in [53:
Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its
minimum value, contact your service representative.
To Next Page
Loading...
