30
3.2.2 Toner Scatter (2)
Parts of a line exhibit splatter. This may occur in a line that is 5 mm (0.2 inches) or
less from the leading edge, or in a line that is 1.5 to 5 mm (0.06 to 0.2 inches) from
an image on the side of the image facing the trailing edge.
CEZ546
5 mm (0.2 in.)
1.5 - 5 mm (0.06 - 0.2 in.)
Cause:
This may occur when printing lines on coated or other slippery paper.
Note:
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
Solution:
The solution depends on the area in which the line splatter occurs. If the splatter
occurs 5 mm (0.2 inches) or less from the leading edge, follow Procedure (a) on
the following page; otherwise, follow Procedure (b) on the following page.
To Next Page
Loading...
