52
<If the area within 90 mm (3.5 inches) of the trailing edge is denser>
1.
In [Advanced Settings] for the custom paper in use, select [20: Transfer
Timing Roller Feed Speed Adj].
2.
Check the present value. Is it lower than -0.5%?
Yes
Contact your service representative.
No
Decrease the value by 0.1 percentage point.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 3. If the problem persists even if you decrease the
value to -0.5%, contact your service representative.
To Next Page
Loading...
