10: Horizontal Stitch
11: Checker Flag
5907
Plug / Play
Sets the brand name and the production name for Windows Plug & Play. This information
is stored in NVRAM. If the NVRAM is defective or has been replaced, these names should
be registered again.
To set the plug and play model name, enter the model number, and then press [#Enter].
5930 Meter Charge
5930 001
Meter Charge
Switches the meter-click charge mode on and off.
[No], [Yes]
Important: Turn the main switch off/on after changing this setting.
No: Meter charge mode disabled (default). This setting is for machines were the operator
is responsible for replacing the AIO and the Maintenance Kit.
• Alert messages are displayed on the operation panel when the AIO or PM parts
reach the limit of their yield.
• The PM counter resets automatically after the user replaces the fusing unit.
Yes: Meter charge mode enabled. This setting is for machines where the service technician
has responsibility for servicing the machine.
• Alert messages are not displayed when the AIO or PM parts reach the limits of their
yield.
• Pressing the [Menu] button displays the meter charge count.
• The service technician must reset the PM counter after completing machine
maintenance.
5930 002
M C Display
Switches the PM alerts on and off.
[No], [Yes]
No: Maintenance Kit alerts will not display.
Yes: Maintenance Kit alerts will display.
Important:
• The setting of SP5930 002 is ignored unless SP5930 001 is set to "Yes".
5. Service Tables
124
To Next Page
Loading...
